Durable and thermo-resistant repair lacquer that meets industry standards. Designed for correcting and lacquering enamelled, lacquered and powder coated surfaces in the kitchen and bathroom.

With the Cramer Ceramic Enamel Spray, heaters, warm-water boilers, facings, refrigerators, washing machines and accessories can be easily refurbished or given a new colour. This product is only splash-proof. Do not use on floors.

Quality:

Highclass 1compound-acrylic-coating. Heat-resistant and fadeless, exellent adhesive power, resistant surface.

Applicability:

Enamelled, coloured and acrylic surfaces.

Sanitary- and RAL-colours or special colours from customers

Colours:

Standard colour card:

colours

Application:

1. Surface must be clean, dry and free from rust.
2. To ensure good adherence of the spray, lightly sand the area to be sprayed with fine (600 grit) sandpaper.
3. Carefully clean up all of the sanding dust. Wipe the area with acetone
4. Hold can 20-30 cm (10-12 inches) from the surface you are repairing, and apply spray with a short stroking motion over the patch. Build up the spray coating slowly. After approximately 1 minute, apply another coat.
5. If you get a run or sag, wipe the spray off with a clean cloth and alcohol. sand again if necessary, and start over.
6. To avoid spatters, clean off the nozzle of the spray tip between passes. If the nozzle starts to clog, hold the can upside-down and blow a little propellant through to clean it out.
7. For maximum durability the spray should be allowed to dry for four days before the fixture is used.